Check Operation; Grounding Instructions - Kenmore 318201460 Manual

Electrical Requirements
120 volt, 60 Hertz, properly grounded branch circuit
protected by a I 5 amp circuit breaker or time delay fuse.
Do not use an extension cord with this cooktop.
Grounding instructions
IMPORTANT
Please read carefully.
For personat safety, this appliance must be properly
grounded.
The power cord of this appliance is equipped with a 3-
prong (grounding) plug which mates with a standard 3-
prong grounding wall receptacle (see Figure 7) to
minimize the possibility of electric, shock hazard from the
appliance.
The wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is
properly grounded.
Preferred Method
Grounding type
wall receptacle
not, under any
circumstances, cut,
remove, or bypass
the grounding
prong.
Check Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be hot enough to
cause burns.
.
Instal[ Burner Caps
This cooktop is equipped with sealed burners as
shown (see Figure 8).
A. Unpack your burner heads and burner caps.
B. Place burner head over each gas orifice,
matching the head with the orifice size. Be
careful not to damage the electrode while
placing the head over the orifice. Make sure
electrode fits correctly into slot in burner head.
C. Place a burner cap on each burner head,
matching the cap size to tile head size. Each
burner cap has an inner locating ring which
centers the cap correctly on the burner head.
D. Be sure that all the burner caps and burner
heads are correctly placed BEFOREusing your
cooktop.
Power supply cord with 3-
prong grounding plug.
Figure 7
Where a standard 2-prong wall receptacle is installed, it
is the personal responsibility and obligation of the
consumer to have it replaced by a properly' grounded 3-
prong wall receptacle.
Do not, under any circumstances, cut or remove the
third (ground} prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Gas Opening
Figure 8
NOTE: There are no burner adjustments necessary on
this cooktop.