Electrical Requirements; Check Operation; Grounding Instructions - Kenmore 79032439903 Installation Instructions Manual

GAS COOKTOP INSTALLATION INSTRUCTIONS
(For 30° & 36" Models)
Electrical Requirements
120 volt, 60 Hertz, properly grounded branch circuit
protected by a 15 amp circuit breaker or time delay fuse.
Do not use an extension cord with this cooktop.
Grounding Instructions
IMPORTANT Please read carefully.
For personal safety, this appliance must be properly
grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle (see Figure 7) to
minimize the possibility of electric shock hazard from the
appliance.
The wail receptacle and circuit should be checked by
a qualified electrician to make sure the receptacle is
properly grounded.
Preferred Method
Grounding type
wall receptacle
Do not, under any
circumstances, cut,
remove, or bypass
the grounding
prong.
Power supply cord with
3-prong grounding plug.
Figure 7
Where a standard 2-prong wall receptacie is installed,
it is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded
3-prong wail receptacle.
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
CNW Disconnect electrical supply cord from wall
receptacle before servicing cooktop.
Check Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be hot enough to
cause burns.
1. Install Burner Caps
This cooktop is equipped with sealed burners. All
pieces are at their place. Take note where they
are. Remove all packaging material. Make sure the
burner caps are properly aligned and leveled. The
burner cap lip (See Fig. 8) should fit snug into the
center of burner head and rest level. Refer to Figs. 9
& 10 for correct and incorrect burner cap placement.
Once in place, you may check the fit by gently sliding
the burner cap from side to side (Fig. 11) to be sure
it is centered and firmly seated. When the burner
cap lip makes contact inside the center of the burner
head you will be able to feel it. Please note that the
burner cap should NOT move off the center of the
burner head when sliding from side to side. NOTE:
There are no burner adjustments necessary on this
cooktop.
Burner Cap
Burner
Head Burner
Correct Burner Cap
Placement - Fig. 9
Incorrect Burner Cap
Placement - Fig. 10
4