Advertisement
Available languages
Available languages
Quick Links
INSTALLATION
AND SERVICE MUST BE PERFORMED BY A QUAUFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasotine or other flammable
vapors and Jiquids in
the vicinity
of this or any other appliance.
Cooktop Dimensions
30" Min. *
...........
(76.2 cm)
b
Cooktop Cutout Dimensions
* 30" (76.2 cm) rain. for unprotected cabinet
24" (61 cm) rain. for protected surface
IMPORTANT INSTALLATION INFORMATION
All electric cooktops run off a single phase, three-wire
or four-wire cable, 240/208 volt, 60 hertz, AC only
electrical supply with ground.
Minimum distance between cooktop and overhead
cabinetry is 30" (76.2 cm).
Figure 1
IMPORTANT INFORMATION FORPROPER
INFRARED TOUCH CONTROL FUNCTION
In order to prevent faulty adjustment of the
controller sensors due to foreign light, the
intensity of illumination at the first power on
should not exceed 1000 Jux.Direct irradiation
of tile touch panel with light from a spotlight
should be avoided during the power process.
If the illumination exceeds 1000 lux, the
control doesn't display the version and stop
the automatic adjustment. In this case turn
down the controls switch of the light till the
illumination is lower than 1000 lux.
30" Ceramk-Glass
21% (543)
31/4 (83)
293/4 (756) 1297Is (759)
201/4 (514) 1201/2 (521)
5 (127)
All dimensions are in inches (cm).
* Allow 2" (5 cm) space below cooktop to clear tile electric cable and allow for installation of tile junction box on the
wall at tile back of tile cooktop.
Printed in the United States
P/N 318201412
(041 1) Rev C
English - pages 1-6
Espat_ol-
pages 7-12
Advertisement
Related Manuals for Kenmore 3182C1412
Summary of Contents for Kenmore 3182C1412
- Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUAUFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasotine or other flammable vapors and Jiquids in the vicinity of this or any other appliance.
- Page 2 Overhead Cabinet Should Not Exceed a Maximum Depth of 13" (33 cm) Bottom of an Unprotected Wood Cutout and Nearest I0" or Metal Cabinet CornbustibleSurface 254cm) Above Countertop 24" (61 cm) Min when 18" Bottom of Wood (457 Metal Cabinet Protected by Not Less 25"...
-
Page 3: Important Notes To The Installer
Important Notes to the Installer Electrical Requirements 1. Read a llinstructions contained i nthese installation Observe all governing codes and tocal ordinances. instructions before installing t hecooktop. A 3-wire or 4-wire single phase 120/240 or 120/208 2. Remove a llpacking material before connecting the Volt, 60 Hz AC only electrical supply is required on a electrical supply t othecooktop. - Page 4 1, tf connecting to a 3-wire supply cable: Unpacking Instructions Connect the green (or bare copper) wire from the appliance (:able and tile supply cable (green or bare) wire to the ground screw inside the junction box (see Figure 4). Connect the remaining wires inside the junction...
- Page 5 2. tf connectingto a 4-wire supply cable (also Cooktop Installation mobile homes): The white neutral wire from the 1. Visually inspect the cooktop for damage. Also make power supply cable must not be connected to the sure all cooktop screws are tight (see Figure 6). junction box.
- Page 6 The retainer brackets MUST be installed, to meet Checking Operation tocal codes or, in their absence, with National Refer to the Use and Care Guide for operation. ElectrkaJ Code ANSJ/NFPA No. 70--Jatest edition, with CSA Standard C22.1, Canadian Electrical Code, Do not touch cooktop glass or elements.
- Page 7 LA mNSTALACmON Y ELSERVmCmO DEBEN SER EFECTUADOS PORUN mNSTALADOR CAUFmCADO. mMPORTANTE: GUARDE ESTAS mNSTRUCCmONES PARAUSODELmNSPECTOR LOCALDE ELECTRmCmDAD. LEAY GUARDE ESTAS mNSTRUCCmONES PARAREFERENCmA FUTURA. PARA SUSEGURtDAD: NoaJmanece ni utiticegasoJina u otrosvapores y J_quidos infJamabJes en ta proximidad de este o de cualquier otro artefacto, Dimensiones de la Estufa tNFORMACION JMPORTANTE PARA LA...
-
Page 8: Acero Inoxidable
El a rmario superior nodebe s obrepasar profundidad m#_xima de13"(33 crn) 30"(76.2 c m) r ain. de espacio entre laparte superior del f og6n y la parte inferior deun armario demadera o 10" combustible metal sin protecciOn.._. cercano sobre la parte superior del armario 24"(61 cm) r ain. - Page 9 Notas importantes para e[ insta[ador Req uisitos el_ctricos Lea todas las instrucciones contenidas en este manual Cumpla con todos los c6digos en vigor y todos los antes de instalar la estufa. reg[amentos locales. Para el suministro el_ctrico solamente se necesita Saque todo el material usado en el embalaje de la estufa antes de conectar el suministro electrico a la corriente con frecuencia de 60 Hz AC y fase Onica de...
- Page 10 Si se conecta a un cable de suministro de tres [nstrucdones de desembalaie alambres: Conecte el alambre verde (o el alambre de cobre sin forro) y alambre blanco del cable del electrodomestico al cable de puesta a tierra (blanco o sin forro) dentro de la caja de empalmes (Figura 4).
- Page 11 Si se conecta a un cable de sum[nistro de cuatro Instalaci6n de la estufa alambres (tambi_n en las casas moviles): el alambre 1.Visualmente inspecciones la estufa para dahos. blanco neutro del cable de suministro electrico no debe Verifique ademas que todos los tornillos de la estufa ser conectado a la caja de empalmes.
- Page 12 Las m_nsuJas de sostenimiento TJENEN QUE Revisi6n de operaci6n instatarse, a satisfacd6n de los c6digos tocaies o, Consulte el Manual de[ Usuario para las instrucciones en su ausenda, con e[ C6digo EJ_ctrko Nadona[ de funcionamiento. ANSIINFPA No. 70--_ltima edki6n, o con [a Norma CSA C22.1, C6digo El_ctrico Canadiense, Parte I No toque elcristaloloselementosdelaestufa.