Real Time Clock; Internal Display Panel - Toshiba TECRA R700 User Manual

Real Time Clock

Problem
The following
message is
Displayed on the
screen:
RTC Power Failure.
Check system. Then
press [F2] key.
Password
Problem
Cannot enter
password
Keyboard
Keyboard problems can be caused by the setup and configuration of the
computer - please refer to chapter 5,
Problem
Some letter keys
produce numbers
Output to screen is
garbled

Internal display panel

Apparent computer's display panel problems may be related to the
User's Manual
Procedure
The charge in the Real Time Clock (RTC) battery
has run out - you will need to set the date and time
in the BIOS setup application by using the following
steps:
1. Turn on the computer while pressing the F2 key.
2. Release the F2 key when theTOSHIBA Leading
Innovation >>>screen appears - the BIOS
setup application will load.
3. Set the date in the System Date field.
4. Set the time in the System Time field.
5. Press F10 - a confirmation message will be
displayed.
6. Press the Y key - the BIOS setup application will
end and the computer will restart.
Procedure
Please refer to the
section in chapter 6, Power and Power-Up Modes
for further information.
The Keyboard
Procedure
Check that the numeric keypad overlay is not
activated - press the FN + F11 hot key and try
typing again.
Please refer to your software's documentation to
ensure that its is not remapping the keyboard in any
way (remapping involves changing or reassigning
the function of each key).
If you are still unable to use the keyboard, you
should contact your reseller, dealer or service
provider.
PORTÉGÉ/TECRA R700 Series
TOSHIBA Password Utility
for further information.
8-7