Table of Contents
Advertisement
2. MAJOR UNIT REPLACEMENT
NOTES:
1.
After replacing the ribbon motor, refer to Section System Mode Manual to perform a Maintenance
Counter clear.
2.
Secure the ribbon motors while inserting a 0.1 mm-thick paper (or folded backing paper) between
the ribbon motor pulley and the idler gear to adjust the backlash. After the ribbon motors is
secured, remove the paper.
Ribbon Motor Pulley (Rewind)
Idler Gear
Ribbon Motor
Pulley (Feed)
4)
Perform a test print to print to confirm that the printer works properly.
2.6 Replacing the Head Up Sensor, Slit Sensor (Rewind/Feed) and Ribbon Motor (Rewind/Feed)
Idler Gear
2-13
EO18-33018
Hide quick links:
Advertisement
Table of Contents
