Troubleshooting - Asus P2B-D2 User Manual

B. NETWORK INTERFACE

Troubleshooting

If the interface can't connect to the network
Make sure the cable is installed properly.
The network cable must be securely attached at both RJ-45 connections (interface and
hub). If the cable is attached but the problem persists, try a different cable. The maxi-
mum allowable distance from network interface or adapter or interface to hub is 100
meters.
If you're directly connecting two computers (no hub), use a crossover cable. Most hubs
require a straight-through cable, while most switches require a crossover cable (see
your hub or switch documentation to verify).
Check the LED lights on the network interface or adapter.
The optional network condition connector module has three diagnostic LEDs . These
lights help indicate if there's a problem with the connector, cable, or hub. The table
below describes the LEDs.
LED Indication
LNK On
Off
ACT On or flashing The interface is sending or receiving network data. The freq-
Off
SPD On
Off
Make sure you're using the correct drivers.
Make sure you're using the drivers that come with your motherboard. The driver filename
contains the letter B (for example, E100BODI.DOS).
Make sure the hub port and the network interface or adapter have the same
duplex setting.
If you configured the network interface for full duplex, make sure the hub port is also
configured for full duplex. Setting the wrong duplex mode can degrade performance,
cause data loss, or result in lost connections.
Meaning
The interface and hub have acknowledged a connection;
the link between the hub and interface is good.
The cable connection between the hub and interface is faulty;
or you have a driver configuration problem.
uency of the flashes varies with the amount of network traffic.
The interface is not sending or receiving network data.
Network connection operating at 100 Mbps.
Network connection operating at 10 Mbps.
ASUS P2B-D2 User's Manual 77