Advertisement
USING
THE REMOTE
LCD
Function
Display
_._
Cooling
\,1,/
-_e )-
Heating
Dehumidifying
(_
Sleeping
BB:BB
Timer
ON
OFF
ON/OFF
BB:
c
Temperature
_.AUTO
Automatic
_
Air Flow Speed
_
HI
_
High Speed
_
Medium Speed
r_"
LO
Low Speed
Transmitter
NOTE:
The functions
of the remote control
buttons are the same
as described
in the
Control Panel section.
TOP VIEW
FRONT VIEW
*
The remote control must be within 16 feet (5 meters) of the receiver on the main
unit. Reception is confirmed by a beep from the main unit.
*
The remote control will not operate if curtains, doors or other material block the
signal from the remote control to the receiver.
*
Prevent any liquid from falling into the remote control. For proper remote control
functioning, do not expose the window kit receiver to direct sunlight or heat.
*
If other appliances react to the remote control, move them out of the way.
*
When using the out-of-room
air conditioning mode, point the remote control to the
receiver in the window kit. Reception is confirmed by an LED flash in the receiver.
*
Do not store the remote control where temperatures will be above 140°F (60°C) or
below 23°F (-5°C).
*
IMPORTANT: If you change the temperature scale (F° or C°) on the main unit
control panel, you must also change the scale to be the same on the remote
control. If not, the main unit scale will revert to that of the remote when you use
the remote control. Hold the Mode button on the remote control for 10 seconds to
change the temperature scale.
NOTE: After
switching
the unit on, the ventilator
fan operates,
but the
compressor
only starts after
the mode indicator
has flashed
for 3 minutes.
Cool air will start to blow once the compressor
starts, but it may take up
to another
5 minutes to feel the cooling
effect
in the room. This is done as
a protection
mechanism
to prolong
compressor
life. Further information
is
available
in the "Troubleshooting"
section.
AIR CONDITIONING
MODE - IN-ROOM
OPERATION
The unit stands in the room to be cooled.
We recommend
starting
your unit early in the morning
on warm
days for
maximum
effect. This unit has a self-evaporation
system to eliminate
water
that condenses in the unit during cooling;
there is no water tank to empty.
The drainage
hose MUST NOT be connected
for IN-ROOM
air conditioning
mode. Please make sure that the water
outlet is closed with the rubber
cap
installed
during
operation.
°
Connect the exhaust hose and the adjustable
air vent to the unit as
displayed
in the illustration.
The hose must be connected
to the side with
the warm
air icon (@).
The warm air emitted
from unit must exit the room
through
the exhaust hose.
°
Use the MODE
button to set the unit function
to COOLING.
Adjust the set
temperature
using the TEMP up or down buttons. The cooling
temperature
can be set from 65°F to 90°F (17°C to 32°C).
14
15
Advertisement
