Page 1
Installation Instructions ProfessionalGas Cooktops 48" Natural Gas Models ZGU48N4G ZGU48N6R ZGU48N6D 48" LP Gas Models ZGU48L4G ZGU48L6R ZGU48L6D 36" Natural Gas Models ZGU36N6 ZGU36N4R ZGU36N4D 36" LP Gas Models ZGU36L6 ZGU36L4R ZGU36L4D Monogram°...
Page 2
Installation instructions BEFORE YOU BEGIN CAUTION'. THESE COOKTOPS SHOULD BE INSTALLED Read these instructions completely and IN CONJUNCTION WITH A SUITABLE carefully. OVERHEAD VENT HOOD. Due to the high heat capacity "IMPORTANT- Save these instructions for of this unit, particular attention should be paid to the local inspector's use.
ZGU36N4R - 4 gas burners and grill 48" Natural Gas Models: ZGU36N6 - 6 gas burners ZGU48N4G -4 gas burners, grill and griddle 36" Liquid Propane Gas Models: ZGU48N6R -6 gas burners and grill ZGU36L4D - 4 gas burners and griddle...
Design Information PRODUCT DIMENSIONS AND CLEARANCES 48" Wide Models 47 7/8 "__ 36" Min. to Combustible 8 7/16 Material From 18" Min. Cooking Allow Additional Clearance Mateda] Surface Below tile CooktopBurner Boxfor the Regulatorand GasConnections 7/8" 22-3/4" Min. 36"WideModels 8-7/16" Allow Additional Clearance Below the CooktopBurner Box for the Regulatorand...
Installation Preparation INSTALLATION OPTIONS ADVANCE PLANNING These cooktops can be installed in standard 24" or Refer to "Dimensions and Clearances" for appropriate deeper 25" cabinets. placement and necessary clearances when planning the installation. • In 24" deep cabinets, the front of the cooktop will project approximately 1-7/8"...
Installation STEP 1 REMOVE PACKAGING Use a hand-truck to move this cooktop. • Flatten the carton and use a piece as a pad on the bottom and back of the hand-truck. Lift the cooktop onto Before moving the cooktop indoors: the hand-truck standing on its end, with the bottom of the cooktop resting against the back of the hand-truck.
Installation STEP 3 INSTALL COOKTOP • Lower the cooktop into the opening. Make sure the cooktop is evenly seated and supported, A side frame gasket will seal the cooktop to the countertop. • "L" brackets with screws are provided to secure the cooktop to the countertop or to adjacent cabinetry.
Installation FINALIZE INSTALLATION Place the burner grates over the burners. Press corner The griddle has two leveling screws beneath the rear of the grate to the cool<top. The grates should be seated flue cover that can be used to adjust to the desired slope. and should not rock.
Installation iNSTALL 9" or 12" HiGH BACKSPLASH Slotsfor Vertical \ Adjustment • Install and level the range or cool{top according to the Backsection installation instructions. Remove the backsplash packaging. Select the back, wall mount panel with mounting screw slots. 1/8t Marl{ a horizontal line on the wall, 1/8"...