Configuring The L3 Tunnel Network - D-Link Unified Access System DWS-3000 Series User Manual

D-Link Unified Access System User Manual
3. From the L3 Features > IP > Interface Configuration page, assign an IP address and
subnet mask to the interface, and make sure routing is enabled.
4. From the Monitoring > L3 Status > VLAN Routing Summary page, view the summary
information for the VLAN routing interface.

Configuring the L3 Tunnel Network

Configure L3 tunneling by modifying or adding a Network. Then, make sure the network is
associated with a VAP on the AP Profile assigned to the APs that wireless clients might use
for roaming. Once you change the AP Profile, re-apply the profile to the APs to reset the APs
that use the profile.
NOTE:
In this example, the L3 Tunnel network is on Network 3 on the Default AP Profile. The SSID
of the network is "L3 Tunnel," and the security mechanism is WPA Enterprise.
192 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
When L3 tunneling is enabled, the VLAN ID for the network is not used. In
fact, the switch puts the management VLAN ID, if any, on the tunneled pack-
ets.