Figure 62. Rf Scan - D-Link Unified Access System DWS-3000 Series User Manual

Status entries in the RF Scan list are collected at a point in time and eventually age out. The
age value for each entry shows how long ago the switch recorded the entry. You can configure
the age out time for status entries on the Administration > Advanced Configuration >
Global page. You can also manually delete status entries. To clear all APs from the RF scan
list, click Delete All.
To configure a Rogue AP to be managed by the switch next time it is discovered, select the
check box next to the MAC address of a detected AP and click Manage. The switch adds the
AP to the Valid AP database as a Managed AP with the default AP profile. Then, you can use
the switch to configure the AP settings. If you use a RADIUS server for AP validation, you
must add the MAC address of the AP to the AP database on the RADIUS server. For more
information, see Appendix B,

Figure 62. RF Scan

Selected APs
to Manage
To identify an AP as an acknowledge rogue, select the check box next to the MAC address of
the AP and click Acknowledge. The switch adds the AP to the Valid AP database as an
Acknowledged Rogue.
When you manage or acknowledge a rogue AP, the switch adds an entry to the valid AP
database but does not change the entry on the RF Scan Status page. However, the next time the
switch discovers the AP, its entry in the RF Scan Status list will be handled based on the
change.
To view additional information about the detected AP, click the MAC address of the AP.
The detailed status for access points detected during the RF scan shows the information on the
summary page plus some additional information learned from the beacon frame, such as
transmission rate.
The following table shows the information the Access Point RF Scan Status page shows for an
individual access point.
"Configuring the External RADIUS Server"
Monitoring Rogue and RF Scan Access Points
7 Monitoring Status and Statistics
on page 179.
137