Dell OptiPlex XE Small Form Factor Service Manual page 4

This option is disabled by default.
Enables or disables the CPUID limit.
Limit CPUID Value
This option is disabled by default.
Virtualization Support
Enables or disables Intel® Virtualization technology.
Virtualization
This option is disabled by default.
Enables or disables the Virtual Machine Monitor (VMM) from utilizing the additional hardware capabilities provided by Intel Virtualization
VT for Direct
technology for direct I/O.
I/O
This option is disabled by default.
Security
Provides restricted access to the computer's system setup program in the same way that access to the system can be restricted
Administrative
with the System Password option.
Password
This option is not set by default.
Displays the current status of the system's password security feature and allows a new system password to be assigned and
System Password
verified.
This option is not set by default.
Enables or disables the user from changing the system password without the administrative password.
Password Changes
This option is enabled by default.
Enables or disables the execute disable mode of the processor.
CPU XD Support
This option is enabled by default.
Enables or disables the optional Computrace® service designed for asset management.
Computrace(R)
You can set this option to:
Deactivate (default)
l
Disable
l
Activate
l
Displays the current status of the password set for the hard drive connected to the SATA-0 connector on the system board.
SATA-0 Password
You can also set a new password. This option is not set by default.
SATA-1 Password
NOTE: The system setup program displays a password for each of the hard drives connected to your system board.
Power Management
Determines how the system responds when AC power is re-applied after a power loss. You can set the AC Recovery to:
AC Recovery
Power Off (default)
l
Power On
l
Last State
l
Sets time to automatically turn on the computer.
Auto On Time
Time is kept in the standard 12-hour format (hours:minutes:seconds).
Change the startup time by typing the values in the time and AM/PM fields.
NOTE: This feature does not work if you turn off your computer using the switch on a power strip or surge protector or if Auto
Power On is set to disabled.
Enables or disables low power mode.
Low Power Mode
This option is disabled by default.
NOTE: When low power mode is enabled, the integrated network card is disabled.
Allows the system to power up when a network interface controller receives a wake up signal. You can set Remote Wakeup to:
Remote Wakeup
Disable (default)
l
Enable
l
Enable with Boot NIC
l
Sets the power management suspend mode to:
Suspend Mode