Assigning An Administrator Password; Operating Your Computer With An Administrator Password Enabled; Deleting Or Changing An Existing Administrator Password - Dell OptiPlex 780 Ultra Small Form Factor Service Manual

computer, and then repeat steps 3 and 4.
5. To assign a new password, follow the procedure in
6. Exit system setup.
Administrator Password
Option Settings
You cannot change or enter a new administrator password if either of the following two options is displayed:
Set — An administrator password is assigned.
Disabled — The administrator password is disabled by a jumper setting on the system board.
You can only assign an administrator password when the following option is displayed:
Not Set — No administrator password is assigned and the password jumper on the system board is in the enabled
position (the default setting).

Assigning an Administrator Password

The administrator password can be the same as the system password.
NOTE: If the two passwords are different, the administrator password can be used as an alternate system
password. However, the system password cannot be used in place of the administrator password.
1. Enter system setup (see
2. Select Admin Password and press <Enter>.
3. Type your new administrator password.
You can use up to 32 characters. To erase a character when entering your password, press <Backspace>. The
password is case sensitive.
Certain key combinations are not valid. If you enter one of these invalid combinations, the speaker emits a beep.
As you press each character key (or the spacebar for a blank space), a placeholder appears.
4. Type your new password a second time to confirm and press OK button. The password setting changes to Set.
5. Exit system setup.
A change to Admin Password becomes effective immediately (no need to restart the computer).

Operating Your Computer With an Administrator Password Enabled

When you enter system setup, the Admin Password option is highlighted, prompting you to type the password.
If you do not type the correct password, the computer lets you view, but not modify, system setup options.
NOTE: You can use Password Status in conjunction with Admin Password to protect the system password from
unauthorized changes.

Deleting or Changing an Existing Administrator Password

Entering System Setup) and verify that Admin Password is set to Not Set.
Assigning a System Password.