Dell OptiPlex 780 Ultra Small Form Factor Service Manual page 13

Sets the power management suspend mode to:
S1
S3 (default)
NOTE: If the AMT Management Engine (ME) of the system is disabled, the S1 suspend mode is
unavailable in the system setup.
Controls the speed of the system fan.
Fan Control
Override
NOTE:
Maintenance
Displays the Service Tag of your computer.
Service Tag
Allows you to create a system asset tag if an asset tag is not already set.
Asset Tag
This option is not set by default.
SERR Messages Controls the SERR Message mechanism.
This option is enabled by default.
Some graphics cards require the SERR Message mechanism be disabled.
Image Server
Specifies how the ImageServer looksup the server address.
Lookup Method
NOTE:
Method.
Specifies the primary static IP address of the ImageServer with which the client software
ImageServer IP
communicates.
The default IP address is 255.255.255.255
NOTE:
IP.
ImageServer Port Specifies the primary IP port of the image server with which the client software communicates.
The default IP port is 06910.
Specifies how the client obtains the IP address.
Client DHCP
Specifies the static IP address of the client.
Client IP
The default IP address is 255.255.255.255
NOTE:
Specifies the subnet mask for the client.
Client
SubnetMask
The default setting is 255.255.255.255
NOTE:
Specifies the gateway IP address for the client.
Client Gateway
The default setting is 255.255.255.255
NOTE:
Displays the current license status.
License Status
When enabled, the fan runs at full speed.
Static IP
DNS
You must set the Integrated NIC to Enable with ImageServer to set the Lookup
You must set the Integrated NIC to Enable with ImageServer to set the ImageServer
Static IP
DHCP (default)
To set Client IP you must set Client DHCP to Static IP
To set Client SubnetMask you must set Client DHCP to Static IP
To set Client SubnetMask you must set Client DHCP to Static IP