Table of Contents
Advertisement
6. Select Run the 32 Bit Dell Diagnostics from the numbered list. If multiple versions are listed, select the version
appropriate for your computer.
7. When the Dell Diagnostics Main Menu appears, select the test you want to run.
Dell Diagnostics Main Menu
1. After the Dell Diagnostics loads and the Main Menu screen appears, click the button for the option you want.
Option
Function
Express
Performs a quick test of devices. This test typically takes 10 to 20 minutes and requires no interaction on
your part. Run Express Test first to increase the possibility of tracing the problem quickly.
Test
Extended
Performs a thorough check of devices. This test typically takes 1 hour or more and requires you to answer
Test
questions periodically.
Custom
Tests a specific device. You can customize the tests you want to run.
Test
Symptom
Lists the most common symptoms encountered and allows you to select a test based on the symptom of the
Tree
problem you are having.
2. If a problem is encountered during a test, a message appears with an error code and a description of the problem.
Write down the error code and problem description and follow the instructions on the screen.
3. If you run a test from the Custom Test or Symptom Tree option, click the applicable tab described in the
following table for more information.
Tab
Function
Results
Displays the results of the test and any error conditions encountered.
Errors
Displays error conditions encountered, error codes, and the problem description.
Help
Describes the test and may indicate requirements for running the test.
Configuration Displays your hardware configuration for the selected device.
The Dell Diagnostics obtains configuration information for all devices from system setup, memory, and
various internal tests, and it displays the information in the device list in the left pane of the screen. The
device list may not display the names of all the components installed on your computer or all devices
attached to your computer.
Parameters
Allows you to customize the test by changing the test settings.
4. When the tests are completed, if you are running the Dell Diagnostics from the Drivers and Utilities disc, remove
the disc.
5. Close the test screen to return to the Main Menu screen. To exit the Dell Diagnostics and restart the computer,
close the Main Menu screen.
Power Button Light Codes
The diagnostic lights give much more information about the system state, but legacy power light states are also
supported in your computer. The power light states are shown in following table.
Power
Light
State
Off
Power is off, light is blank.
Initial state of light at power up.
Blinking
Indicates system has power, but the POWER_GOOD signal is not yet active.
Amber
If the Hard Drive light is off, it is probable that the power supply needs to be replaced.
If the Hard Drive light on, it is probable that an onboard regulator or VRM has failed. Look at the
diagnostic lights for further information.
Solid
Description
Hide quick links:
Advertisement
Table of Contents
