Table of Contents
Advertisement
Assembling and dismantling low-profile units
Do not dispose of the slot cover. If you remove the board again, you must reinstall the slot
!
cover (cooling, fire protection or EMC regulations to be complied with).
Removing the holding plate
►
Open the casing (see "Opening the casing").
1
Installing a board
►
Push the board up to its slot as far as the stop.
►
Press the board into the slot so that it engages.
►
If necessary, plug the lines on the board again.
Removing a board
►
Disconnect the cables connected to the board.
►
Pull the board out of the slot.
Re-assembling the holding plate
1
VFY-SCED103S, edition 1
1
2
1
2
►
Undo the screws (1) and remove the
holding plate (2).
►
Position the holding plate (2) so that it
secures the components.
►
Screw in the screws (1) previously removed
again.
System expansions
27
Advertisement
Table of Contents
