Rapid Resume Logic; Power Saver Mode - Clifford Ultramax XL-4500 Owner's Manual

Table of Contents

Rapid Resume Logic

This DEI

system will store its current state to non-volatile mem-

ory. If power is lost and then reconnected the system will recall

the stored state from memory. This means if the unit is in Valet

Mode and the battery is disconnected for any reason, such as ser-

vicing the car, when the battery is reconnected the unit will still

be in Valet

Mode. This applies to all states of the system includ-

ing arm, disarm, and Valet

Your system will automatically enter Power Saver Mode while

armed or in Valet

Mode, after a period of time in which no oper-

ation has been performed. This lowers the current draw on the

vehicle's battery and prevents the system from draining the bat-

tery. Power Saver Mode takes over under the following conditions:

Power Saver when the system is armed: After the system has

been armed for 24 hours the LED will flash at half its normal

rate, decreasing the system's current draw.

Power Saver in Valet

Mode the LED illuminates steadily. If the vehicle is not used

(ignition is not turned on) for a one hour period while the

Mode.

Mode: When the system enters Valet

2000 Directed Electronics, Inc.

Table of Contents