Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Clifford 330X1
Summary of Contents for Clifford 330X1
- Page 1 V e h i c l e S e c u r i t y S y s t e m Model 330X1 /330X2 /330X3 Owner’s Guide...
-
Page 2: Limited Consumer Warranty
Limited consumer warranty For a period of one calendar year from the date of purchase of this auto-security device, Directed Electronics, (Directed) promises to the ORIGINAL PURCHASER to repair or replace (at Directed's election) with a comparable reconditioned model, any Directed unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories which proves to be defective in workmanship or material under reasonable use, provided the following... - Page 3 California state laws and applicable federal law shall apply and govern the dispute. TO THE MAXIMUM EXTENT ALLOWED BY LAW, ALL WARRANTIES ARE EXCLUDED, INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY AND/OR ANY AND ALL WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD.
-
Page 4: Table Of Contents
Contents Limited consumer warranty ..i Trademarks and copyrights ..1 What is included ... . .2 Important information ..2 Using your system . -
Page 5: What Is Included
What is included Control module and harness Ultrasonic sensor Valet switch ® Pre-wired Blue status LED 515 ESP Smart Self-Power siren Important information Congratulations on the purchase of your security system. Due to the complexity of this system, it must be installed by an authorised dealer only. -
Page 6: Using Your System
Using your system Arming your system You can activate, or arm, the system by locking the doors with your fac- tory keyless entry transmitter. When the system arms, you will hear a short siren sound and see the indicator lights flash once. While the system is armed, the status LED will flash about twice a sec- ond, to indicate that the system is actively protecting your vehicle. -
Page 7: Armed Protection
Armed protection When armed, your vehicle is protected as follows: If a door is opened, the system will immediately start sound- ing the siren and flashing the indicator lights. By turning on the ignition the siren pulses and the indicator lights flash. -
Page 8: Disarming
Disarming To disarm the system, unlock the doors using your factory keyless trans- mitter. The siren will sound twice, and the indicator lights will flash twice. If the siren sounds four or five times when disarming, this is called Tamper Alert. Refer to the Diagnostics section of this guide. Disarming without a transmitter This feature allows you to override the system without the transmitter should it be lost, damaged or disabled. - Page 9 Press the button the same number of times as 2nd digit, the turn the ignition Off and On. Press the button same number of times as 3rd digit, then turn the ignition Off and On. Press the button same number of times as 4th digit, then turn the ignition OFF.
-
Page 10: Panic Mode
Valet mode ® You can prevent your system from arming, by using Valet is very useful when washing the vehicle or having it serviced. In Valet Mode, the system will not arm, even with the transmitter, but all con- venience functions (door locks, boot release, etc.) will work normally. To enter or exit Valet®... - Page 11 If enabled, Press the lock button on your factory keyless transmitter two-times, and then press it again within 3 to 7 seconds to enter Panic Mode. The siren will sound and the indicator lights will flash for 30 sec- onds. To stop Panic Mode at any time, press the unlock button on your factory transmitter.
-
Page 12: Nuisance Prevention Circuitry
Nuisance Prevention Circuitry Your system has Nuisance Prevention Circuitry prevents annoying repetitive trigger sequences due to faulty door pin switches or environmental conditions such as thunder, jackhammers, airport noise, etc. Here’s how it works: The alarm triggers ten times. Each time, the same sensor or switch is triggering the alarm. -
Page 13: Diagnostics
Diagnostics The microprocessor at the heart of your system is constantly monitor- ing all of the switches and sensors connected to it. It detects any faulty switches and sensors and prevents them from disabling the entire sys- tem. The microprocessor will also record and report any triggers that occurred during your absence. -
Page 14: Table Of Zones
Table of zones The zone number is the number of LED flashes used by the system to identify that input. The standard input assignments are listed below. ZONE (Number LED Flashes) The LED will not report if the Warn Away response is triggered. Rapid resume logic This system will store its current state to non-volatile memory. -
Page 15: Glossary Of Terms
Glossary of terms Control Module: The “brain” of your system. Usually hidden under- neath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all of the alarm’s functions. Failsafe ® Starter Kill (if equipped): An automatic switch controlled by the security system which prevents the vehicle’s starter from cranking whenever the system is armed. -
Page 16: Notes
Notes © 2008 Directed Electronics - all rights reserved... -
Page 17: Quick Reference Guide
QUICK REFERENCE GUIDE: To arm the system ■ You can arm the system by locking the doors with your factory keyless entry transmitter. When the system arms, your will hear a short chirp, and see the indicator lights flash once. To disarm the system ■... - Page 18 © 2008 Directed Electronics - all rights reserved...
- Page 19 The company behind this system is Directed Electronics, Inc. Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, DIRECTED is ISO 9001 registered.