Regarding The Indicator Lamps - 3M Multimedia Projector S15i Operator's Manual

Troubleshooting

Regarding the indicator lamps

indicator have the meanings as described in the table below. Please respond
in accordance with the instructions within the table. If the same indication is
displayed after the treatment, or if an indication other than the following is
displayed, please contact your dealer or service company.
POWER LAMP
indicator indicator
Lighting Turned
In Orange off
Blinking
Turned
In
Green off
Lighting Turned
In Green off
Blinking
Turned
In
off
Blinking
In
Red tionary)
Blinking
In
Red
Lighting
or
In Red
Lighting
In Red
Blinking
In
Red
Blinking
or
In
Red
Lighting
In Red
48
TEMP
indicator
Turned The projector is in a standby state.
off Please refer to the section "Power On/Off". (
Turned The projector is warming up.
off Please wait.
Turned
The projector is in an on state.
off Ordinary operations may be performed.
Turned The projector is cooling down.
off Please wait.
The projector is cooling down. A certain error
has been detected.
tionary)
and then perform the proper response measure using
the item descriptions below as reference.
The lamp does not light, and there is a
possibility that interior portion has become
heated.
Please turn the power off, and allow the unit to cool
down at least 20 minutes. After the projector has
Turned
the following items, and then turn the power on again.
off
• Is there blockage of the air passage aperture?
• Does the peripheral temperature exceed 35°C?
If the same indication is displayed after the treatment,
please change the lamp by referring to the section
"Lamp". (
(attached).
Please turn the power off, and allow the unit to cool
down at least 45 minutes. After the projector has
Turned
off
the attachment state of the lamp door. After performing
any needed maintenance, turn the power on again. If
the same indication is displayed after the treatment,
please contact your dealer or service company.
Description
41)
© 3M 2006
16)
3M™ Digital Projector S15i