Adjusting The Projector's Elevator - 3M Multimedia Projector S15i Operator's Manual

Setting up

Adjusting the projector's elevator

WARNING
immediately after use. Handling while the projector is in a high temperature
could cause a burn and/or malfunction to the projector. Before operating, make
sure that the power switch is off, that the power cord is not plugged in, and that
the projector is cool adequately.
CAUTION
result in malfunction. To prevent damaging the projector and injuring yourself,
always hold the projector whenever using the elevator buttons to adjust the
elevator feet.
horizontally.
You can use the elevator feet to make adjustments if the surface on which you
need to set the projector is uneven or if you otherwise need to adjust the angle of
projection. The adjustment range of the elevator feet is 0 to 9 degrees.
1.
Press and hold in the elevator buttons while holding the projector.
The elevator buttons and the elevator feet are on the both sides.
Raise or lower the projector to the desired height and then release the
2.
elevator buttons.
When you release the elevator buttons, the elevator feet will lock into position.
3.
the elevator feet by hand.
12
Do not adjust the projector's elevator during use or
Elevator feet
Elevator button
© 3M 2006 3M™ Digital Projector S15i