3M Wall Display Quick Start Manual

W A L L D I S P L A Y Q U I C K S T A R T G U I D E
STARTUP
Plug power
1
cord into
outlet.
2
Make sure the Master Power
Switch is On. It is located underneath
the Wall Display on the right side of
the power cord. (Leave this switch On.)
The On/Off button will turn amber in
approximately 5 seconds.
• After pressing, the On/Off button blinks green, then stays green.
• The projection arm extends out from the top of Wall Display.
• The fan motor starts.
• The lamp comes on. (Allow approximately 1 minute for full illumination.)
"Wherever there's a great meeting, you'll find 3M."
E D
W A L L D I S P L A Y Q U I C K S T A R T G U I D E
7 8 - 6 9 7 0 - 9 0 7 5 - 7
3
Press the
On/Off button.
™
I U G T R A T S K C I U Q
SHUTDOWN
Press the On/Off button.
1
(Leave the Master Power Switch turned On.)
fold
Y A L P S I D L L A W
P a g e 1 o f 2
2 The On/Off button blinks
red for 30 seconds. The
projection arm closes. The
fan runs for 5 minutes.
00:00:00 00:05:00
Note: After the On/Off button
is pressed, the unit will not
respond to any other commands
for 30 seconds.
www.3M.com/walldisplay
Innovation