Advertisement
Step 1: LOWER MAIN FRAME ASSEMBLY
Locate the following
for this step:
• Lower lat tower (Item #1)
• Left main frame (Item
#2)
• Right main frame (Item
#3)
• Two (2) 3/8X3" bolts (Item #51)
• Four (4) 3/8" washers (Item
#54)
• Two (2) 3/8" nylon lock nuts (Item
#51)
[] Place the left main frame (Item
#2) into the
saddle bracket
of the lower lat tower (Item
#1)
as shown in Figure A.
[] Insert a 3/8"X3"
bolt (Item
#51) with a
washer on it through
the appropriate
holes,
place a 3/8" washer (Item
#54) and then a 3/8"
nylon lock nut (Item
#57) on the bolt, hand
tighten at this time.
[] Place the mating right hand side of the main
frame (Item #3) next to the left side of the
frame in the lower lat tower saddle bracket
(Item
#t) and repeat step above.
Note: Hand tighten
all bolts at this stage.
Figure
A
I Components
for this step
are in Box 2 & Box 4
Step 2: ADJUSTABLE
PULLEY SYSTEM
Locate the following for this step:
• Adjustable
Pulley System (Item #6)
(_)
• Two (2) Adjustable
Pulley System bolt spacers
/
(Item #7, twist tied to Adjustable
Pulley System)
]
• Two (2) 3/8"X2-1/2"
bolts (Item #49)
• Two (2) 3/8"X3/4" bolts (Item #46)
• Four (4) 3/8" washers (Item #54)
• Two (2) Adjustable
Pulley System lock knobs (Item #8)
_4k_3r_
_
[] Remove twist ties from bolt spacers and slide Adjustable
Pulley System (Item #6) into main frame uprights
as shown
in Figure B.
_ .&
Note: The side with two large holes faces away from the machine.
®
[] Insert both 3/8"X2-1/2"
bolts (Item #49) with 3/8" washers
(Item #54) into chest slide spacers and hand tighten
into the back
of lower lat tower (Item
#1) (NOTE: DO NOT OVERTIGHTEN)
Note: Inserting
the top bolt first will help you align the parts.
[] Hand tighten the 3/8"X3/4"
bolts (Item
#46) with 3/8" washers
(Item #54) into the uprights
of the main frame (Items
#2&3).
Figure
B
[] Make sure all the holes are properly
aligned and screw the two
spring-loaded
locking knob assemblies
(Item #8) into the back side
of the Adjustable
Pulley System as shown in figure B. Tighten the locking
knobs to the Adjustable
Pulley System with an adjustable
wrench.
Components
for this step
are in Box 4
Note: Do not unwrap
the two pulley assemblies
that are attached
to the Adjustable
Pulley System
at this time.
[] Securely tighten
all bolts that have been placed on the unit up to this stage.
Unit appears
like this
following
this assembly
step
Advertisement
