Advertisement
Step 5: INSTALLING
THE LEG EXTENSION
ATTACHMENT
[] Place the leg extension
on the end of the rail and tighten
the two small star knobs (Item
#68) through the sides of
the leg extension
rail bracket
and into the rail as shown in
Figure U.
[] Take the leg attachment
cables and snap them into the
cable storage clips on the bracket
under the seat rail.
Unit appears
like
this following
this
assembly
step
(shown
with
optional/at
tower)
!
Figure
U
BEFORE EACH USE OF THE EQUIPMENT,
CHECK ALL FASTENERS,
SNAP HOOKS,
CABLES AND PULLEY
FUNCTIONS.
TIGHTEN
AND FASTEN AS NEEDED.
CHECK
PULLEYS
AND CABLES FOR
WEAR AND FUNCTION.
ASSEMBLING
YOUR BOWFLEX T-BAR
Your T-bar was shipped fully assembled
with the metal bar
resting in the loops of the nylon strap. If, however, the bar and
the nylon strap separated
during shipping,
follow these
instructions
for reassembly.
[] The nylon strap has one flat side and one side with several
twists. Lay the nylon strap on a flat surface with the flat
side down, as shown in Figure V.
Lift the strap by the metal rings and hold it in front of you.
Turn the strap completely
over with the twisted
side down.
Grab the strap in the center with the index finger of one
hand. See Figure W.
[] Use your index finger and thumb of your free hand to
spread the strap into two loops, as shown in Figure X
[] Using your free hand, slide the bar through the loops.
Remove your fingers from the loop. The strap should wrap
around the bar evenly and slide loosely and freely around
the bar. See figure Y.
Figure
X
Figure
Y
Figure
V
Figure
W
Advertisement
