Advertisement
Step 7: SEAT RAIL INSTALLATION
The following
parts are required
for this step:
• Seat Rail {Item #10)
• One (1) 3/8"X5"
bolt {Item #53)
• Two (2) 3/8" washers
{Item #54)
• One (1) 3/8" nylon lock nut {Item #57)
• Large Knob {Item #37)
[] If you have not already done so, remove
the twist-tie
that holds the rail spacer blocks
and tube in place on the side of the seat rail.
[] Slide the seat rail, right side up, into the
main frame and rest it on the cross bar as
shown in Figure F.
[] Slide the 3/8"X5"
bolt {Item #53) with a
washer through
main frame and seat rail as
shown in Figure F. Place 3/8" washer {Item
#54) and 3/8" nylon lock nut
(Item #57) on bolt and tighten.
[] Place the large knob (Item #37) into the
hole in the top of the frame and tighten.
Figure
F
Step 8: SEAT INSTALLATION
Locate the following
parts for this step:
• Seat Assembly
[] Pull out and lock the pin on the left side of the seat
assembly and slide the seat onto the rail as shown in
Figure G.
Figure
G
Components
for this
I
step are in Box 3
I
Unit appears
like this
following
this
assembly
step
Advertisement
