Call Announce Intercom - Fujitsu SRS-1050 User Manual

Chapter 3
The feature operates in one of two modes, two-way or one-way intercom. Two-way intercom immediately activates
the speaker and microphone of the called digital set, allowing two-way communication. One-way intercom activates
only the speaker, leaving the microphone of the recipient's digital set turned off in the interest of privacy. The
recipient must press the MIC-OFF button to respond to the call screener.
The call announce intercom is distinct from the network-based intercom feature. Call announce intercom activates
automatically. With the network-based intercom, the recipient must answer the intercom call. You could, however,
use the network-based feature to simplify dialing for call announce intercom, allowing the call screener to dial one
or two digits rather than the recipient's full extension number. You could also eliminate dialing entirely with
dedicated intercom, another network-based feature.
Figure 3-1 below shows a typical application of call announce intercom.
Call Screener
Directory Numbers
3110
3111
3112*
*Designated for intercom
This section discusses requirements for setting up call announce intercom followed by the procedures to:
Enable or disable call announce intercom
Use call announce intercom to announce a call
Setting up for call announce intercom
To be used, this feature must be enabled on the digital sets of call recipients; no setup is necessary on the
screener's digital set. In fact, the screener can have any kind of telephone, even a non-ISDN unit. Any number of
digital sets can be enabled, allowing a central screener to screen calls for several people.
Specifying the Directory Number for Intercom
When enabling the feature, you must specify a Directory Number, which, when used by the screener to call the
recipient, activates the intercom automatically. All recipients can specify the same Directory Number, giving the
screener a single Directory Number for all call announce intercom calls. Normal calls can still be made from this
Directory Number to numbers not set up for intercom. Up to three Directory Numbers may be programmed.
When specifying the Directory Number for intercom, you can enter just the extension number of the call screener or
the complete number. For example, for a call screener at 926-3112, you could enter
3112
( SRS -1050 Local Features
Call Recipient
DIAGRAM
Call announce intercom setup:
Activating Directory
Number = 3112
Intercom mode = 1-way or 2-way
Figure 3-1: Call announce intercom application
or
Page 3-37