Fujitsu SRS-1050 User Manual page 39

Chapter 2
c. Press an idle Call
Appearance button, which
will normally give you a dial
tone.
4. If your call is answered,
converse with the called party.
5. When your conversation ends,
hang up by pressing SPEAKER.
Note the call duration; it
vanishes after about three
seconds.
Note: Onhook dialing. In place
of steps 1 and 2, you can dial
the number first and then
press SPEAKER. The phone
automatically dials the
number. The number you
enter remains available for
dialing for about three
minutes.
You can also use a one-touch
button, which automatically
selects an idle CA and dials
the number. Steps 1 and 2 are
therefore unnecessary when
you use a one-touch button.
(See also "Handsfree, Handset,
and Headset Modes", in Chapter
3, "Local Features".)
or
( SRS -1050 Voice Features
If you are already using the
headset and talking on
another call
1. Handle the existing call in one of
the following ways:
a. End the call by pressing
SPEAKER or DROP. Then
press SPEAKER again to get
a dial tone.
b. Press an idle Call
Appearance button to get a
dial tone. This will either
hang up on the active call or
automatically place it on
hold, depending on your
installation. Your System
Administrator can tell you
which occurs.
c. Press HOLD to save the
active call so you can return
to it later. Then press
SPEAKER again to get a dial
tone.
2. Dial the desired number by
pressing the keys on the
numeric keypad.
3. If your call is not answered,
hang up as follows:
a. Press the SPEAKER button.
b. Press DROP.
or
or
or
continued
Page 2-11