Appendix A Installation - Fujitsu SRS-1050 User Manual

Appendix A
APPENDIX A
INSTALLATION
When you receive your SRS-
1050, plug the telephone line
from the wall into the LINE
socket at the back of the set.
If the LCD displays a date and
time, you have power. If not,
you'll need a power supply to
connect to the AC wall socket
and the power socket at the
back of the phone.
If you plan to use a headset,
disconnect the handset from
the jack on the left side of the
phone and plug the headset
into the same jack.
Use Chapter 3 to enable
headset use and to set the
clock/calendar, phone
parameters, and other local
features.
Find out from your system
administrator what numbers and
features have been assigned to
buttons on your phone, and label
those buttons
appropriately.installation
These instructions are intended
mainly for System
Administrators or service
personnel or end users that are
installing the SRS-1050.
( SRS -1050 Installation
Installation of the SRS-1050
involves two steps:
Connecting the set to the
network.
Entering Service Profile
Identifier (SPID).
Labeling the set.
UNA DATA CLEAR
1 2
Standard Softkey Layout
INSTALLING THE SRS-1050
ISDN equipment may be
installed in a number of
configurations. In most
installations, the
supplementary equipment (NT1
and power) is located in a wire
closet in your building. If this
is the case in your installation,
please skip to the section
below: "Connecting to the
network".
In some installations, the NT1
and power are located at the
user's desk.
Two drawings are included that
illustrate the connections you
may need to make when the
power and NT1 are located at
the user's desk.
REG
Key Menu
3 4
Page A-1