Adding A Memory Board - Fujitsu PRIMERGY RX600 S6 Operating Manual

CSS components
Ê Carefully press the memory board into its slot (see
Ê Press both handles downwards (2) so that both green release tabs engage.
Ê Press the ATTN button.
Ê Wait until the ATTN LED is turned off.
Ê Close the server as described in
8.1.5.6

Adding a memory board

To add memory boards during operation, proceed as follows:
Ê Open the server (see
Ê Remove the air baffle of the respective memory board slot.
Figure 33: Removing the memory air baffle to add a memory board
Ê Press on the top of the memory air baffle (1), move it in the direction of the
arrow (2) and out of the housing.
I
Keep the memory air baffle for future use.
Ê Install the equipped memory board into the respective slot.
I
Memory boards that you insert must suit the fitting rules and the
appropriate configuration. See the "System Board D3141 for
PRIMERGY RX600 S6 Technical Manual" for details.
114
"Closing the server" on page
"Opening the server" on page
Operating Manual
figure 33 on page
127.
125).
RX600 S6
114).