Reading Documents In Adf Mode - Fujitsu M3093EX Operator's Manual

4.3 Reading Documents in ADF Mode

This section explains how to read documents using the automatic
document feeder. If the following steps are not closely followed, a
feed error may occur.
1
(a) Paper quality
(b) Paper weight
(c) Paper size
(d) Items to avoid
NOTICE: The important document which shall not be torn must be read by flatbet.
NOTICE: Carbonless papers have the chemical composition which damages the pad and
pickroller. Therefore, note the following remarks
Cleaning:
Replacement of parts: The life of the pad and the pickroller may be shorter than the
Check the documents as follows:
• Wood-free paper.
• PPC paper; Specified by XEROX Corporation.
• 13.91bs to 27.81bs
• Letter, Legal, A4, A5, B5
• The following documents may be hard to read by ADF. Before
you start the large quantity reading, check that the document is
read appropriately. If the reading is not appropriate, read them
by flatbet.
– Paper with a clip or staple.
– Paper that has ink which is not dry.
– Paper thickness is not constant, such as an envelope.
– Paper that has large rumples or curl. (See NOTICE)
– Paper that has folds or tears.
– Tracing paper.
– Coating paper.
– Carbon paper.
– Paper that is smaller than A5 size or larger than A4 width.
– Items other than paper, such as clothes, metal sheet, or OHP
film.
– Photographic paper.
– Paper that has perforations on its side.
– Paper that has a shape other than square.
– Paper that is very thin.
If the miss pick occurs frequently, clean the pad and pickroller
in accordance with the section 5.3.2.
case that PPC document is fed. Replacement cycle of the pad
and the pickroller may be 100,000 sheets or more if the paper
quality is good and cleaning is done well. Before you start the
large quantity reading, check the replacemtne cycle of them
and prepare pads and pickrollers.
4 – 5