Connecting The Usb Cable - Fujitsu ScanSnap fi-5110EOX2 Getting Started

2. Insert the connectors of the AC adapter to the scanner
inlet and a power outlet.
Inlet

2.2.2. Connecting the USB cable

Follow the procedure below to connect the USB cable.
●
Use the USB cable supplied with this scanner.
The operation with a commercially available USB
cable is not guaranteed.
●
When connecting to a USB hub, be sure to
connect the scanner to the hub nearest to your
computer (first stage). If you connect it to a USB
hub from the second stage onwards, ScanSnap
may not operate correctly.
1. Remove the seal from the USB connector.
2. Connect the scanner and your computer with the USB
cable.
3. Open the Paper chute cover of scanner.
If the scanner is not automatically turned on,
press the [POWER] button on the scanner.
Your computer will automatically detect the scanner.
For Windows 98
There is a request to insert a disk. When such a message
appeared, insert the Windows 98 CD-ROM into the
CD-ROM drive.
Then click the [OK] button.
For Windows Me
The new hardware is detected and the installation will be
completed automatically.
For Windows 2000
When [Digital Signature not Found]
click the [Yes] button.
8 |
Outlet
USB cable
,
appears
For Windows XP
1) When [Found New Hardware Wizard] window appears,
select "No, not this time" and click the [Next >] button.
(The above window only appears when the Service Pack 2
is installed.)
2) Click the [Next >] button in the following window.
3) When [Hardware Installation] appears,
click the [Continue Anyway] button.
The window to notify completion of installation appears.
Click the [Finish] button when the installation is
4)
completed.
The installation of ScanSnap is complete!
The "ScanSnap Manager" icon in the task tray is
displayed as
When the icon remains as
button to turn off the scanner and then press the
[POWER] button again to restart the scanner.
(Allow at least 5 seconds when you turn on/off the
scanner.
When you turn off/on the scanner, press the
HINT
[POWER] button for longer than one second.
*For preventing mis-operation, the [POWER] button
does not work unless it is pressed for longer than
one second.
S .
, press the [POWER]