Fujitsu ScanSnap fi-5110EOX2 Getting Started page 24

6. Remove the Pick roller from the shaft.
Pull out the shaft from the Pick roller while lifting up
its tab.
Tab
If you push up the pick roller tab using your
fingernail, your fingernail may be hurt or get
chipped. If you cannot push it up successfully
with your fingernail, use a paper clip to push
up the pick roller tab.
7. Attach the new Pick roller to the shaft.
Insert the shaft aligning the protrusion with the slot
on the new Pick roller.
Shaft
8. Install the Pick roller with its shaft into the bushing
and set the shaft to the slot while lowering it.
Shaft
20 |
Shaft
Pick roller
1
2
Pick roller
Slot
Protrusion
Bushing
Pick roller
9. Fix the Pick roller bushing (left) by rotating it in the
direction of the arrow.
Pick roller bushing
Pick roller
Make sure that the Pick roller is
completely attached and correctly
installed. Otherwise, document jams or
other feeding errors may occur.
10. Attach the sheet guide to the scanner.
While holding the handle on the sheet guide, set the sheet
guide into the scanner.
Sheet guide
You should hear the sheet guide click when it
returns to its original position.
11. Close the ADF.
ADF cover
You should hear the ADF cover click when it
returns to its original position.
12. Turn on the scanner.
ScanSnap Manager icon changes from
Shaft
Handle
Craw
S
to .