Fujitsu fi-5220C Getting Started page 14

4. Insert the Setup CD-ROM into the CD drive.
⇒
<SETUP DISK START UP SCREEN>
appears.
This screen may not appear when the
ATTENTION
"Autoplay" setting of your PC is off. In this
case, run "Install.exe" in this CD-ROM directly
from the "Explorer" or "My Computer".
5. Click [INSTALL PRODUCTS].
6. Click [TWAIN Driver] on the window below.
7. Error Recovery Guide Installation window
appears.
Error Recovery Guide is a software that dis-
plays troubleshooting information on screen
when any scanner error occurs, and its installa-
tion is highly recommended. However, it can
be installed later if you do not install it in this
step.
When you select [Yes] for installing the Error
ATTENTION
Recovery Guide, [Choose Setup Language]
window appears. Select a language and fol-
low the instructions on the window. Error
Recovery Guide will automatically finish fin-
ishing its installation. Please wait until the
installation of TWAIN driver automatically
starts.
6
8. Select a language used for installation on
[Choose Setup Language] window and click
[OK].
9. Install the application following the instructions
on the window.
10. When the [InstallShield Wiizard Complete] win-
dow appears, click [Finish].
Your computer will be restarted and the scanner will be
detected. Do not remove the Setup CD-ROM from the
CD drive until your PC has completely restarted.
Depending on the OS, these operations
ATTENTION
may be necessary.
For Windows 98:
When a request for inserting the CD-ROM
for Windows 98 appears, insert it into the
CD drive and click the [OK] button.
For Windows 2000:
When [Digital Signature not Found]
appears, click [Yes].
Now the installation of the scanner driver is completed.
To confirm whether the installation was
ATTENTION
successful, perform a scanning operation
with an application that complies with the
TWAIN regulations such as ScandAll 21.