Configuring Serial Ptz Operations - Serial Menu; Rs485 Baud Rate; Camera List - Sony Ipela SNCA-ZX104 User Manual
Hybrid camera receiver
Hide thumbs
Also See for Ipela SNCA-ZX104:
- Brochure (2 pages) ,
- Installation manual (2 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Tip
The unit can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
button on the unit. For details, see the supplied
Installation Manual.
Backup setting data
Saves the setting data of the unit in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the unit.
The file name preset at the factory is “snca-zx104.cfg.”
Restore setting
Loads the stored setting data of the unit.
Click Browse and select the file in which the setting data
is stored. Click OK, and the unit is adjusted according to
the loaded data, and restarted.
Note
With Restore setting, some items in the Network menu
(page 18) cannot be restored.
Configuring Serial PTZ
Operations
— Serial Menu
Serial
When you click
in the Setup menu, the Serial
menu appears.
Use this menu to perform settings related to sending
commands to a camera over a network connection when
receiving analog camera-controlling Pelco-D protocol
commands via the RS-485 port.
Also set devices connected to this system accordingly.
RS485 baud rate
Select from 1200, 2400, 4800 or 9600.
Camera list
This list is for converting the camera numbers included
within commands received via the RS-485 port into IP
address and port numbers.
Backup camera list
Saves this unit’s camera list to a file.
Click Save..., and follow the instructions on the Web
browser to specify the folder and save the unit’s camera
list.
Restore camera list
Restores a camera list to this unit that has been saved to
a file.
Click Browse... and select the file in which the camera
list is stored. Click OK to load the selected file and
update the camera list.
Page 17
Advertisement
Table of Contents
