GE JB745SFSS Use And Care Manual page 35

Sugary spillovers (such as
jellies, fudge, candy, syrups)
or melted plastics can cause
pitting of the surface of your
cooktop (not covered by the
warranty) unless the spill is
removed while still hot. Special
care should be taken when
removing hot substances.
Be sure to use a new, sharp
razor scraper.
Do not use a dull or nicked
blade.
Metal Marks and Scratches
Be careful not to slide pots and pans
across your cooktop. It will leave metal
markings on the cooktop surface.
These marks are removable using the
CERAMA BRYTE Ceramic Cooktop Cleaner
®
with the CERAMA BRYTE
for Ceramic Cooktops.
If pots with a thin overlay of aluminum
or copper are allowed to boil dry, the
overlay may leave black discoloration
on the cooktop.
Cooktop Seal
To clean the cooktop seal around the edges
of the glass, lay a wet cloth on it for a few
Damage from Sugary Spills and Melted Plastic
Turn off all surface units. Remove hot
pans.
Wearing an oven mitt:
a. Use a single-edge razor
blade scraper (CERAMA BRYTE
Ceramic Cooktop Scraper)
to move the spill to a cool
area on the cooktop.
b. Remove the spill with paper towels.
To Order Parts
To order CERAMA BRYTE
®
Cleaner and the cooktop scraper, please call
our toll-free number:
National Parts Center
CERAMA BRYTE Ceramic
®
Cooktop Cleaner . . . . . . . . . .#WX10X300
CERAMA BRYTE Ceramic
®
Cooktop Scraper . . . . . . . . . .#WX10X0302
Kit . . . . . . . . . . . . . . . . . . . . . . . .#WB64X5027
(Kit includes cream and cooktop scraper)
NOTE: Carefully check the bottom of pans for
roughness that would scratch the cooktop.
Cleaning Pad
®
minutes, then wipe clean with nonabrasive
cleaners.
.
®
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced.
In this case, service will be necessary.
Ceramic Cooktop CERAMA BRYTE
Ceramic Cooktops . . . . . . .#WX10X350
800.626.2002
GEAppliances.com
This should be removed immediately
before heating again or the
discoloration may be permanent.
Any remaining spillover should be left
until the surface of the cooktop has
cooled.
Don't use the surface units again until
all of the residue has been completely
removed.
Cleaning Pads for
®
35