Table of Contents
Advertisement
User's Manual
Table 5.4 HARDWRE Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
HARDWRE
Options
Items
<BUFFER>
(continued)
<PIN-18>
N/C:
+5V
<INTRFCE>
PARALEL
SERIAL
AUTO-2S
AUTO-4S
AUTO-6S
AUTO10S
AUTO15S
AUTO20S
Serial Interface Items. The following <FORMAT> to <DUPLEX>
items are not printed when you select the PARALEL option for the
<INTRFCE> item. Be sure that the options selected on the printer
are the same as the options selected using your computer operating
system or your software. Refer to the documentation provided for
your computer and software.
<FORMAT>
8NONE 1
8NONE 2
8EVEN 1
8ODD 1
7EVEN 1
7ODD 1
7MARK 1
USING SETUP MODE
Description
NOTE:
• 0BYTE option is recommended
only for graphics application.
• With 96KB selected, the printer
cannot accept any download font
data.
Does not out put +5V to pin 18 of the
Centronics cable.
Outputs +5V to pin 18 of the
Centronics cable.
Selects the type of the interface to the
computer.
Centronics parallel interface
RS-232C serial interface
Auto interface selection mode
Both interfaces are ready for
communication.
Specify the timing of regarding the
selected interface as being inactive.
Number of
data bits
Parity bit
8
None
8
None
8
Even
8
Odd
7
Even
7
Odd
7
Mark
Number of
stop bits
1
2
1
1
1
1
1
5-29
Advertisement
Table of Contents
