4060-xxx
Interconnect board assembly removal
CAUTION: Unplug the printer before you begin.
Warning: Observe all ESD precautions while handling ESD-sensitive parts. See
sensitive parts" on page
Note: Any time the interconnect board assembly is replaced, the Configuration ID must be reset in
NVRAM on the new interconnect board. Go to
1.
Remove any feature or option cards from the interconnect board.
2.
Remove the inner shield. See
3.
Remove the LVPS access plate and disconnect the LVPS cable from CN2 (A).
4.
Disconnect cables J4 and J5 from the interconnect board.
4-40
Service Manual
4-1.
"Setting configuration ID" on page
"Inner shield removal" on page
A
"Handling ESD-
3-18.
4-34.