Removing The Dc-In Port - Dell Precision M4500 Service Manual

Back to Contents Page
DC-In Port
Dell Precision™ Mobile Workstation M4500 Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the DC-In Port

NOTE: You may need to install Adobe™ Flash Player™ from Adobe.com in order to view the illustrations below.
1. Follow the procedures in Before Working Inside Your
2. Remove the battery.
3. Remove the access panel.
4. Remove the subscriber identity module (SIM)
5. Remove the optical drive.
6. Remove the keyboard.
7. Remove the coin-cell battery.
8. Remove the hinge covers.
9. Remove the display assembly.
10. Remove the hard drive.
11. Remove the Latitude ON™ Flash card.
12. Remove the wireless wide area network (WWAN)
13. Remove the wireless local area network (WLAN)
14. Remove the heat sink and fan
15. Remove the processor.
16. Remove the palm rest assembly.
17. Remove the Bluetooth® card.
18. Remove the ExpressCard board.
19. Remove the SD card board.
20. Remove the system board.
21. Remove the I/O port card.
22. Release the DC-in port from its routing guides on the chassis.
23. Lift the DC-In port up and remove it from the chassis.
Replacing the DC-In Port
To replace the DC-In port, perform the above steps in reverse order.
Back to Contents Page
Computer.
card.
card.
card.
assembly.