Dell Precision™ Mobile Workstation M4500 Service Manual
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Display Assembly
NOTE:
You may need to install Adobe™ Flash Player™ from Adobe.com in order to view the illustrations below.
1. Follow the procedures in
Before Working Inside Your
2. Remove the battery.
3. Remove the
access
panel.
4. Remove the
hinge covers.
5. Loosen the captive screws that secure the display cable to the system board and disconnect the display cable from its connector on the system board.
6. Disconnect and release the antenna cables from wireless local area network (WLAN) card.
7. Remove the screws that secure the display assembly to the computer.
8. Disconnect and release the antenna cables from wireless wide area network (WWAN) card.
9. Remove the screws that secure the display assembly to the computer.
10. Lift the display assembly up and away from the computer.
Replacing the Display Assembly
To replace the display assembly, perform the above steps in reverse order.