Removing The Vga Connector Board - Dell Inspiron 15 Intel Service Manual

Back to Contents Page
VGA Connector Board
Dell™ Inspiron™ N5010/M5010 Service Manual
Removing the VGA Connector Board
Replacing the VGA Connector Board
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Removing the VGA Connector Board
1. Follow the instructions in Before You
2. Remove the battery (see Removing the
3. Remove the base cover (see
4. Remove memory module(s) (see
5. Remove the optical drive (see
6. Remove the keyboard (see
7. Remove the palm rest (see
8. Remove the display assembly (see
9. Remove the middle cover (see
10. Disconnect the VGA connector board cable from the connector on the system board and remove it from the routing guide.
11. Remove the VGA connector board from the tab on the computer base.
12. Lift the VGA connector board along with the cable off the computer base.
1 VGA connector board 2
Begin.
Battery).
Removing the Base Cover).
Removing the Memory Module(s)).
Removing the Optical Drive).
Removing the Keyboard).
Removing the Palm Rest).
Removing the Display Assembly).
Removing the Middle Cover).
tab
Removing the Battery) before working inside the