Dell PowerConnect W-Airwave User Manual page 23

Assign Campus, Building and Floor Number
Find the Floor Info Section and assign the following information
Setting Default
Building
pull down
Floor
Ceiling Height
Ceiling
Attenuation
Assign optional information (planner, installer, and owner)
Find the Optional Information section and enter the following information
1.
Setting Default
Name Floor 0.0
Owner NA
Planner NA
Installer NA
Click the "Save" (the Next button will change to Save) button to save the file.
2.
You will be redirected to the VisualRF
3.
Layer Controller
Find the CAD Layers section
1.
Unselect the layers which are not required. There will be slight delay, because each request makes a
2.
round trip to the server.
Click the "Save and Close" button to begin provisioning APs or "Save and New" button for
3.
uploading another floor plan.
After clicking "Save and Close" you will be redirected back into QuickView where you can provision
4.
APs, IDFs, and wired infrastructure.
Visual RF and Visual RF Plan | User Guide P
NA Use this pull down to associate the floor with a building which associate it
to a Campus as well
0.0 The floor number. You can enter negative numbers for basements.
Note: Each floor plan within a building must have a unique floor number.
10 Specifies the height from the floor to the ceiling. This will default to the
ceiling height for the building, but you can override here if needed for atria
or basements.
20 Specifies the attenuation characteristics in dB of the ceiling or the floor
above.
A descriptive name for the floor. It inherits the floor number if nothing is entered.
The owner of the floor (used in diagnostics and alerts).
The person in charge of planning the RF layout for the floor.
The person in charge of installing RF equipment for the floor.
Floor Plans page.
Description
Description
23