D-Link Dsa-3600 Configuration - AMIGOPOD PowerConnect W Clearpass 100 Software Integration Manual

D-Link DSA-3600 Configuration

The following configuration procedure assumes that the D-Link DSA-3600 has been powered up
and a basic IP configuration has been applied through the steps detailed in the Quick Install
Guide. The following table again reviews the IP Addressing used in the test environment but this
would be replaced with the site specific details of each customer deployment:
DSA WAN1 IP Address
DSA Default Service Zone IP Address
Internet Gateway Address
amigopod IP Address
amigopod RADIUS port
Depending on your network design the D-Link DSA-3600 may need to be configured to perform
Network Address Translation (NAT) on the Internet port. As can be seen from the previous Lab
Topology diagram, to simplify our lab routing environment NAT has been enabled.
If NAT is required in your network design, the DSA NAT settings can be found under
System ! Service Zones ! Default ! Configure as shown below:
CONFIDENTIAL
10.0.20.166
192.168.1.1
10.0.20.1
10.0.20.54
Auth 1812 Acc 1813 (default settings)
13