Brocade Communications Systems PowerConnect B-FCXs Release Note page 7

Feature
QoS for the SX-FI48GPP
module
Buffer profiles on the SX-
FI48GPP module
IGMP snooping querier
enhancement
Flexible VE numbering
New SNMP MIBs
IronWare Software Release 07.2.00a for Brocade FastIron switches
Release Notes v 1.0
Description
The SX-FI48GPP module supports QoS for
packets in an oversubscribed environment. QoS
configuration and functionality is different on
the SX-FI48GPP compared to other interface
modules.
To increase or decrease the queue depth limits
for a port on the SX-FI48GPP module, you must
configure a buffer profile that defines the
queue depth limits, and apply the buffer profile
to the port.
You can use the show ip multicast vlan
command to display the querier information
for a VLAN. This command displays the VLAN
interface status and if there is any other
querier present with the lowest IP address.
When configuring virtual routing interfaces on
a device, you can now specify a number from 1
through 4095. However, the total number of
virtual routing interfaces that are configured
must not exceed the system-max limit of 512.
SNMP MIB support has been added for the
following features:
Dynamic ARP Inspection
DHCP snooping
IP Source Guard
EMCP
Refer to the FastIron
Configuration Guide, section
entitled...
Configuring Quality of Service
Dynamic buffer allocation for QoS
priorities for FastIron X Series
devices
Displaying querier information
Assigning an IP address to a
virtual interface
IronWare MIB Reference Guide
Page 7 of 55