Network Setup - D-Link DCS-931L User Manual

Section 3 - Configuration
This section allows you to configure your network settings.
DHCP:
Select this connection if you have a DHCP server running on your network and
would like a dynamic IP address to be updated to your camera automatically.
Static IP Client: You may obtain a static or fixed IP address and other network information
from your network administrator for your camera. A static IP address will ease
you for accessing your camera in the future.
IP Address: The fixed IP address
Subnet Mask: The default value is "255.255.255.0. " Used to determine if the
destination is the same subnet.
Default Gateway: The gateway used to forward frames to destinations
in a different subnet. Invalid gateway settings may cause the failure of
transmissions to a different subnet.
Primary DNS: Primary domain name server that translates names to IP
addresses.
Secondary DNS: Secondary domain name server to backup the Primary DNS.
PPPoE Settings: If you are using a PPPoE connection, enable it and enter the User Name and
Password for your PPPoE account. You can get this information from your
Internet service provider (ISP).
Port Settings: You may configure a Second HTTP port that will allow you to connect to
the camera via a standard web browser. The port can be set to a number
other than the default TCP ports 80. A corresponding port must be opened
on the router. For example, if the port is changed to 1010, users must type
http://192.168.0.100:1010 instead of only "http://192.168.0.100".
UPnP Settings: Enable this setting to configure your camera as a UPnP device in the network.
D-Link DCS-931L User Manual

Network Setup

24 24