Wps - Push Button Setup - D-Link DCS-931L User Manual

Section 2 - Installation

WPS - Push Button Setup

Alternatively, you may create a secure wireless connection using the WPS Button on the back of the camera.
To create a WPS connection:
Step 1
Make sure the camera is powered on, then press and hold the WPS button for
three seconds. The blue WPS status LED will start blinking.
Step 2
Press the WPS button on your router within 60 seconds. The WPS button is
usually located on the front or side of your router. On some routers, you may
need to log in to the web interface and click on an on-screen button to activate
the WPS feature. If you are not sure where the WPS button is on your router,
please refer to your router's User Manual.
WPS Button
The DCS-931L will automatically create a secure wireless connection to your
router. While connecting, the green LED will flash and your camera will reboot.
D-Link DCS-931L User Manual 17