Using Coaxial Cable; Connecting An Antenna Or Cable Tv (No Box) - Dynex DX-32L200NA14 User Manual

10
DX-32L200NA14
Using coaxial cable (good)
To connect a cable or satellite box using coaxial cable:
1
Make sure that your TV's power cord is unplugged,
and all connected equipment is turned off.
2
Connect a coaxial cable (not provided) to the ANT
CABLE IN jack on the side of your TV and to the
antenna or cable TV wall jack.
Coaxial cable
3
Plug your TV's power cord into a power outlet, then
turn on your TV.
4
Press INPUT to open the INPUT SOURCE list.
5
Press or to highlight TV then press ENTER.
6
If you cannot tune to channels you know exist, scan
for channels. See
channels" on page 24.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
• If the signal level for a channel is weak, the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally
recorded in HD.
Cable or satellite box
Coaxial cable
Side of TV
"Automatically scanning for
Connecting an antenna or cable TV (no
box)
To connect an antenna or cable TV (no box):
1
Make sure that your TV's power cord is unplugged,
and all connected equipment is turned off.
2
Connect a coaxial cable (not provided) to the
ANT/CABLE IN jack on the side of your TV and to the
antenna or cable TV wall jack.
3
Plug your TV's power cord into a power outlet, then
turn on your TV.
4
Press INPUT to open the INPUT SOURCE list.
5
Press or to highlight TV then press ENTER.
6
If you cannot tune to channels you know exist, scan
for channels. S See
channels" on page 24.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
• If the signal level for a channel is weak, the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally
recorded in HD.
Making connections
Antenna or
cable TV (no box)
Coaxial cable
Side of TV
"Automatically scanning for