Using 3D Viewing Mode - Sharp PG-LW2000 Operation Manual

Viewing Stereoscopic 3D Images (Continued)

Using 3D Viewing Mode

Use the following procedure to project
3D images.
For operation of the 3D LCD shutter
glasses and the 3D-video playback
equipment, see the corresponding
operation manual.
Projecting 3D images
1 1
Turn the projector on.
2 2
Turn the 3D-video playback
equipment on.
• Set the 3D-video playback equipment so
that it outputs one of the signals listed in
the Compatibility Chart in this operation
manual.
3 3
Switch the Input mode of the
projector to enable input of 3D
video signals.
4 4
Operate the 3D-video playback
equipment and play back the 3D
content.
5 5
Turn the 3D LCD shutter glasses
on and place them over your eyes.
52
ENTER button
O/Q buttons
3D MODE button
6 6
Press 3D MODE on the remote
control to display the 3D MODE
menu.
Info
• If "An invalid button has been pressed."
is displayed, a 3D-compatible signal is
not being input. Check the output signal
on the playback equipment.
7 7 Press Q to set "DLP
"On".
8 8
Press ENTER to switch the mode
and enable more natural 3D
image viewing.
Warning!
• If the projector, 3D-video playback
equipment, and 3D LCD shutter
glasses are not properly set, you may
experience eye strain in addition to not
being able to view the images in 3D.
9 9
Press 3D MODE.
• The 3D MODE menu will disappear.
Note
• If the images are not displayed in 3D, repeat
steps 6 to 8.
• You can also use "DLP
Link™ Invert" on the menu screen to change
the 3D setting.
Ending 3D projection
1 1
Press 3D MODE on the remote
control to display the 3D MODE
menu.
2 2 Press O to set "DLP
"Off".
3 3
Press 3D MODE.
• The 3D MODE menu will disappear.
® Link™" to
® Link™" and "DLP ®
® Link™" to