Using 3D Viewing Mode - Sharp XG-SV200X Operation Manual

Using 3D Viewing Mode

Use the following procedure to project
3D images.
For operation of the 3D LCD shutter
glasses and the 3D-video playback
equipment, see the corresponding
operation manual.
Projecting 3D images
1 1
Turn the projector on.
2 2
Turn the 3D-video playback
equipment on.
• Set the 3D-video playback equipment so
that it outputs one of the signals listed in
the Compatibility Chart in this operation
manual.
3 3
Switch the Input mode of the
projector to enable input of 3D
video signals.
4 4
Operate the 3D-video playback
equipment and play back the 3D
content.
5 5
Turn the 3D LCD shutter glasses
on and place them over your eyes.
O/Q buttons
ENTER button
3D MODE button
6 6
Press 3D MODE on the remote
control to display the 3D MODE
menu.
Info
• If "An invalid button has been pressed."
is displayed, a 3D-compatible signal is
not being input. Check the output signal
on the playback equipment.
7 7 Press Q to set "DLP
"On".
8 8
Press ENTER to switch the mode
and enable more natural 3D
image viewing.
Warning!
• If the projector, 3D-video playback
equipment, and 3D LCD shutter
glasses are not properly set, you may
experience eye strain in addition to not
being able to view the images in 3D.
9 9
Press 3D MODE.
• The 3D MODE menu will disappear.
Note
• If the images are not displayed in 3D, repeat
steps 6 to 8.
• You can also use "DLP
Link™ Invert" on the menu screen to change
the 3D setting.
Ending 3D projection
1 1
Press 3D MODE on the remote
control to display the 3D MODE
menu.
2 2 Press O to set "DLP
"Off".
3 3
Press 3D MODE.
• The 3D MODE menu will disappear.
®
Link™" to
® ®
Link™" and "DLP
®
Link™" to
67