Sharp AR-RB1 Service Manual page 16

<3> Upper turnover roller
1) Remove the rear and front casings.
2) Remove the bypass drive PWB.
3) Remove the E-ring, Mylar, belt, pulley, gears, pins and bearings,
and take out (B) the upper turnover roller.
B
<4>Lower turnover roller
1) Remove the rear and front casings.
2) Remove (A) the E-ring, and slide the bearing over.
3) Remove the belt, and take out the lower turnover roller unit.
4) Remove the E-rings, pulley, pin, Mylar and bearings from (B) the
lower turnover roller.
A
<5> Upper transport roller
1) Remove the rear and front casings.
2) Remove the E-rings, belt, pulley, pin and bearings.
3) Remove (A) the upper transport roller.
A
A
B
AR-RB1 DISASSEMBLY, ASSEMBLY AND MAINTENANCE 5 - 3
<6> Lower transport roller
1) Remove the rear and front casings.
2) Remove (A) the E-ring, belt and pulley.
3) Remove (B) the E-rings, slide the bearing over, and take out the
lower transport roller unit.
4) Remove the pin and bearing from (C) the lower transport roller.
A
<7> Delivery roller
1) Remove the rear and front casings.
2) Remove the screws, remove (A), and take out (B) the left door unit.
3) Remove the E-rings, belt, pulley, pin and bearings. Take out (C)
the delivery roller.
C
B
B
A
B
C