Hardware Installation - D-Link DVX-2000MS-10P - VoiceCenter IP Phone Sys 10P Quick Installation Manual

Hardware Installation

Connecting the DVX-2000MS Base Unit
Plug the power adapter into an AC outlet or power strip and plug the
other end into the AC input on the back of the DVX-2000MS Base
Unit. The power LED will light up to indicate proper connection.
Connect one end of the Ethernet cable to the LAN Port on the back
of the DVX-2000MS Base Unit and connect the other end of the
Ethernet cable to a Local Area Network via switch or hub. The LAN
LED will light up to indicate proper connection.
When you have connected the DVX-2000MS to your network, it should
look like the diagram below:
 D-Link VoiceCenter Quick Install Guide