Paper Feeding Problems - Dell 1125 Mono Laser MFP User Manual

Front cover is open.
Cover Open
Rear Cover is open.
Cover Open - Rear
Cover
Paper size mismatch.
Paper Size Error
Paper jam in ADF.
Paper jam
ADF area
Unspecified scanner error.
Scanner module
error
Scanning attempted while no memory
Scan Memory Full
available.
No tone or comms error.
Fax TX Error
Fax comms error.
Fax RX Error
Check telephone
cable
Dial failed.
Dial Fail
Attempted to send a fax while the system is
Memory Full
printing a job.
Attempted to receive a fax while the system is
Memory Full
doing a scan job with 1200dpi.
Attempted to enter a new delay fax when the
Fax Jobs Full
delay fax list is full.
Attempted to add a new group when the
Group No. is
number has already been assigned.
assigned
Attempted to add a new speed dial no. when
This Speed Num is
the number has already been assigned
Assigned
Attempted to input a speed dial number which
No. not
has not been assigned.
Assigned
Troubleshooting
The following chart lists some conditions that may occur and the recommended solutions. Follow the suggested solutions until the problem is corrected. If the
problem persists, contact Dell.

Paper Feeding Problems

Condition
Paper in the output tray is misaligned or falls
out from the output tray.
Paper is jammed during printing.
Paper sticks together.
Multiple sheets of paper do not feed.
Paper does not feed into the printer.
The paper keeps jamming.
Transparencies stick together in the paper
exit.
Close front cover.
Close rear cover.
Insert correct paper size.
Clear jam (see
Restart printer.
Wait for current print/fax job to complete and retry.
Check connections and try again.
Check connections and try again.
Try again.
Scanning is stopped and display shows whether or not operator want to start
transmission of correctly scanned pages or abort transmission.
Reception is stopped and transmitter may result in Comm. Error. Operator must
release memory space by clearing printer error for further reception.
Release some fax jobs and retry.
Select an alternate number or delete and replace an existing number.
Select an alternate number or delete and replace an existing number.
Select an alternate number or create speed dial entry and retry.
Suggested solutions
Please check the media packaging for the correct preferred printing side or turn the paper in the input
l
tray over. For more information, see the instructions on the media packaging.
Clear the paper jam. See Clearing Jams in the Paper
l
Ensure that there is not too much paper in the paper tray. The paper tray can hold up to 250 sheets of
l
paper, depending on the thickness of your paper.
Make sure that you are using the correct type of paper. See
l
Remove paper from the paper tray and flex or fan the paper.
l
Humid conditions may cause some paper to stick together.
l
Different types of paper may be stacked in the paper tray. Load paper of only one type, size and
l
weight.
If multiple sheets have caused a paper jam, clear the paper jam. See
l
Remove any obstructions from inside the printer. See
l
Paper has not been loaded correctly. Remove paper from the tray and reload it correctly.
l
There is too much paper in the paper tray. Remove excess paper from the tray.
l
The paper is too thick. Use only paper that meets the specifications required by the printer. See
l
Recommended Paper.
Make sure that the correct paper size is selected. See
l
An incorrect type of paper is being used. Use only paper that meets the specifications required by the
l
printer. See Recommended
There may be debris inside the printer. Open the front cover and remove the debris.
l
Use only the transparencies specifically designed for a laser printer. Remove each transparency as it
l
exits from the printer.
Clearing Jams in the ADF).
Paths.
Recommended
Cleaning the
Setting the Paper
Paper.
Paper.
Clearing Jams in the Paper Paths.
Interior.
Size.