Table of Contents
Advertisement
1. Working from the rear of the monitor, attach Soundbar by aligning the two slots with the two tabs along the bottom rear of the monitor.
2. Slide the Soundbar to the left until it snaps into the place.
3. Connect the sound bar with the power brick.
4. Plug the power cables of the power brick into a nearby outlet.
5. Insert the lime green mini stereo plug from the rear of the Soundbar into the computer's audio output jack.
NOTE: The graphic is for illustration only. Product appearance may vary.
NOTE: The base removal is not necessary to install the sound bar. Shown with base detached for illustration purposes only.
Specification
System Frequency Response 95 Hz to 20 kHz @ 10 dB below avg. SPL
Total Power Output
Headphone Jack
Output Power
Input Sensitivity for
Rated Output
Input Impedance
Maximum Input Signal
Voltage
Controls
Input Cables
Power Requirements
Power Cord Length
Operating Temperature
Range
Humidity, Non-condensing
Troubleshooting
The following table contains general information about common audio problems you might encounter.
COMMON
WHAT YOU EXPERIENCE
SYMPTOMS
No Sound
No power to Soundbar - the
power indicator is off.
14 W continuous average power (all speakers operating) @ 10% (THD+N), 1 kHz (FTC
rated)
40 mW continuous average power (RL = 32Ω) @ 10% (THD+N), 1 kHz
500 ± 50 mVrms @ 1 kHz
>10kΩ
2 Vrms
Power On/Off Volume Control
3.0 m ± 0.1 m AWG26 black cable attached to enclosure, with 3.5 mm lime green stereo
plug
DC12V, 1.5A +/-10% (Power brick is required)
305 mm +/- 15 mm AWG22 black cable attached to enclosure, with DC plug (5.5 x 2.1 x
12 mm)
10°C to 40°C
95% RH @ 40°C
Turn the Power/Volume knob on the Soundbar clockwise to the middle position; check if
the power indicator (green LED) on the front of the Soundbar is illuminated.
POSSIBLE SOLUTIONS
Hide quick links:
Advertisement
Table of Contents
